The bit is your communication link to his horse with the reins, pressure from the legs and body position. Depending on your driving style and his experience level and the condition of the horse's mouth, different bits will be more appropriate than others. In general, most horses that do not have been mistreated will have what is called a "soft mouth" which means that your mouth is not being harmed by the misuse of a bit or ill-treatment by a careless driver. Horses that have been misused by the excessive use of cruel and a little that is known as "hard-mouthed" and require specialized bit combinations to control horse.
Fortunately, there are few horses that have been mistreated and most horses have a soft mouth. The most commonly recommended type of bit will ensure that both the pilot is in control and provide protection to the horse's mouth. Getting the right bit size is essential in the little comfortable for the horse and avoid pinching the sensitive skin on the side of the mouth. In general, most light horse breeds using a five-inch bits, which is measured through of the drill. Some horses have a mouth wider or narrower, so a good driver will always be measured through the horse's mouth on the outside of the lips, then add an additional half inch. If you start with five-inch bit, then you can see if you need to go wider or narrower, or you can try a variety bit and measure the best fit. Note that the bit must be ¼ inch on each side of the outside of the horse's mouth to fit properly. A string may be used and measured if it wants to treat a variety of bit sizes. Only part of the string through the language of the horse on the bit normally resting place and measure ¼ inch on each side to get the final bit size.
English and western bits are different, as are bits for racing, dressage and other types of specialty events. The most common bit styles in both English and Western riding is a bit of steak, which is also softer in the mouth the horse. A little steak is two bars that connect at the center, with western steak also known as the sidewalk steak, since it will have two new "halt" pieces on each side. Fillet bits are ideal for beginners, since even if the pilot pulls harder than necessary on the bit the horse's mouth does not hurt. The horses that are hard mouth may require other types of bits, such as full curbs, rollers, and Kimberwick Pelham bit, depending on driving style. Since these bits can and will cause damage to the horse if used incorrectly, are not recommended for inexperienced pilots significantly.
Always clean your little later every trip to prevent accumulation of debris, Goop and spit in his hand. "It'sa good idea to have some spare that can be fastened around the head flange and used, while some others are thoroughly cleaned. Soaking the bit in warm water for an hour is usually dry to smooth any material that can be removed with a brush Bristle Brush and a good cleaning.
About the Author:
Susanne Malloy is an avid equestrian and an editor for
http://www.EnglishSaddleShop.com,
your complete resource for new and used
English saddles
, riding apparel, and tack.
Article Source: ArticlesBase.com – A Bit About Horse Bits
